120
HP-IB Programming
Standard STATUS Commands
Command Descriptions
command
:STATus:OPERation:CONDition?
syntax
:STATus:OPERation:CONDiton?
description
This query reads the contents of the OPERation:CONDition
register. Only two bits of the condition register are used.
example
OUTPUT 724;":STAT:OPER:COND?"
ENTER 724;A$
command
:STATus:OPERation[:EVENt]?
syntax
:STATus:OPERation[:EVENt]?
description
This query reads the contents of the OPERation:EVENt register.
Only two bits of the event register are used (whether these bits
contain information depends on the transition register
configuration):.
example
OUTPUT 724;":STAT:OPER?"
ENTER 724;A$
command
:STATus:OPERation:ENABle
syntax
:STATus:OPERation:ENABle<wsp><value>
description
This command sets the bits in the ENABle register that enables the
contents of the EVENt register to affect the Status Byte (STB).
Setting a bit in this register to 1 enables the corresponding bit in the
EVENt register to affect bit 7 of the Status Byte.
Bit
Mnemonic
Bit Value
8
Zeroing A
256
9
Zeroing B
512
Bit
Mnemonic
Bit Value
8
Zeroing A
256
9
Zeroing B
512
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
