248
6000 Series Oscilloscope User’s Guide
5
Making Measurements
1
Press the
Quick Meas
&
Select
and select
Delay
. Press the
Settings
softkey to select the source channels and slope for
the delay measurement.
The default Delay settings measure from the rising edge of
channel 1 to the rising edge of channel 2.
2
Press the
Measure Delay
softkey to make the measurement.
The following example shows a delay measurement between the
rising edge of channel 1 and the rising edge of channel 2.
Figure 39
Delay Measurement
Phase
Phase is the calculated phase shift from source 1 to source 2,
expressed in degrees. Negative phase shift values indicate that
the rising edge of source 1 occurred after the rising edge of
source 2.
Phase =
Delay
Source 1 Period
----------------------------------------- X 360
Summary of Contents for InfiniiVision 6000 Series
