130
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
5
Commands by Subsystem
See Also
•
"Introduction to Common (*) Commands"
Example Code
' RESET - This command puts the oscilloscope into a known state.
' This statement is very important for programs to work as expected.
' Most of the following initialization commands are initialized by
' *RST.
It is not necessary to reinitialize them unless the default
' setting is not suitable for your application.
myScope.WriteString "*RST"
' Reset the oscilloscope to the defaults.
Example program from the start:
"VISA COM Example in Visual Basic"
Slope
Positive
HF Reject and noise reject
Off
Holdoff
60 ns
External probe attenuation
AutoProbe (if AutoProbe is connected),
otherwise 1.0:1
External Units
Volts
External Impedance
1 M Ohm
Trigger Menu
Summary of Contents for InfiniiVision 7000A Series
