394
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
5
Commands by Subsystem
:POD<n>:SIZE
Command Syntax
:POD<n>:SIZE <value>
<n> ::= An integer, 1 or 2, is attached as a suffix to the command and
defines the group of channels that are affected by the command.
POD1 ::= D0-D7
POD2 ::= D8-D15
<value> ::= {SMALl | MEDium | LARGe}
The :POD<n>:SIZE command specifies the size of digital channels on the
display.
Query Syntax
:POD<n>:SIZE?
The :POD<n>:SIZE? query returns the size setting for the specified group of
channels.
Return Format
<size_value><NL>
<size_value> ::= {SMAL | MED | LARG}
See Also
•
"Introduction to :POD<n> Commands"
•
•
N O T E
This command is only valid for the MSO models.
Summary of Contents for InfiniiVision 7000A Series
