Getting Started
3
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
57
Other Ways of Sending Commands
Standard Commands for Programmable Instrumentation (SCPI) can be sent
via a Telnet socket or through the Browser Web Control.
Telnet Sockets
The following information is provided for programmers who wish to
control the oscilloscope with SCPI commands in a Telnet session.
To connect to the oscilloscope via a telnet socket, issue the following
command:
telnet <hostname> 5024
where <hostname> is the hostname of the oscilloscope. This will give you a
command line with prompt.
For a command line without a prompt, use port 5025. For example:
telnet <hostname> 5025
Sending SCPI Commands Using Browser Web Control
To send SCPI commands using the Browser Web Control feature, establish
a connection to the oscilloscope via LAN as described in the
7000 Series
Oscilloscopes User's Guide
. When you make the connection to the
oscilloscope via LAN and the instrument's welcome page is displayed,
select the
Browser Web Control
tab, then select the
Remote
Programming
link.
Summary of Contents for InfiniiVision 7000A Series
