836
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
12
Programming Examples
' The range value is eight times the volts per division.
myScope.DoCommand(":CHANnel1:RANGe 8")
' TIME_RANGE - Sets the full scale horizontal time in seconds.
' The range value is ten times the time per division.
myScope.DoCommand(":TIMebase:RANGe 2e-3")
' TIME_REFERENCE - Possible values are LEFT and CENTER:
'
- LEFT sets the display reference one time division from
'
the left.
'
- CENTER sets the display reference to the center of the
'
screen.
myScope.DoCommand(":TIMebase:REFerence CENTer")
' TRIGGER_SOURCE - Selects the channel that actually produces
' the TV trigger.
Any channel can be selected.
myScope.DoCommand(":TRIGger:TV:SOURCe CHANnel1")
' TRIGGER_MODE - Set the trigger mode to, EDGE, GLITch,
' PATTern, CAN, DURation, IIC, LIN, SEQuence, SPI, TV,
' UART, or USB.
myScope.DoCommand(":TRIGger:MODE EDGE")
' TRIGGER_EDGE_SLOPE - Set the slope of the edge for the
' trigger to either POSITIVE or NEGATIVE.
myScope.DoCommand(":TRIGger:EDGE:SLOPe POSitive")
End Sub
'
' Extra()
' --------------------------------------------------------------
' The commands in this function are not executed and are shown
' for reference purposes only.
To execute these commands, call
' this function from main.
'
Private Shared Sub Extra()
' RUN_STOP (not executed in this example):
'
- RUN starts the acquisition of data for the active
'
waveform display.
'
- STOP stops the data acquisition and turns off AUTOSTORE.
'
myScope.DoCommand(":RUN")
myScope.DoCommand(":STOP")
' VIEW_BLANK (not executed in this example):
'
- VIEW turns on (starts displaying) an active channel or
'
pixel memory.
'
- BLANK turns off (stops displaying) a specified channel or
'
pixel memory.
'
myScope.DoCommand(":BLANk CHANnel1")
myScope.DoCommand(":VIEW CHANnel1")
Summary of Contents for InfiniiVision 7000A Series
