Commands by Subsystem
5
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
121
Return Format
<status><NL>
<status> ::= 0,..,255; an integer in NR1 format.
See Also
•
"Introduction to Common (*) Commands"
•
"*ESE (Standard Event Status Enable)"
•
•
•
1
RQL
Request Control
The device is requesting control. (Not used.)
0
OPC
Operation Complete
Operation is complete.
Table 42 Standard Event Status Register (ESR) (continued)
Bit
Name
Description
When Set (1 = High = True), Indicates:
N O T E
Reading the Standard Event Status Register clears it. High or 1 indicates the bit is true.
Summary of Contents for InfiniiVision 7000A Series
