Commands by Subsystem
5
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
241
:DIGital<n>:POSition
Command Syntax
:DIGital<n>:POSition <position>
<position> ::= integer in NR1 format.
<n> ::= An integer, 0, 1,..,15, is attached as a suffix to the command
and defines the logic channel that is affected by the command.
The :DIGital<n>:POSition command sets the position of the specified
channel.
Query Syntax
:DIGital<n>:POSition?
The :DIGital<n>:POSition? query returns the position of the specified
channel.
Return Format
<position><NL>
<position> ::= integer in NR1 format.
See Also
•
"Introduction to :DIGital<n> Commands"
Channel Size
Position
Top
Bottom
Large
0-7
7
0
Medium
0-15
15
0
Small
0-31
31
0
N O T E
This command is only valid for the MSO models.
Summary of Contents for InfiniiVision 7000A Series
