Commands by Subsystem
5
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
427
:SBUS:DISPlay
Command Syntax
:SBUS:DISPlay <display>
<display> ::= {{1 | ON} | {0 | OFF}}
The :SBUS:DISPlay command turns displaying of the serial decode bus on
or off.
Query Syntax
:SBUS:DISPlay?
The :SBUS:DISPlay? query returns the current display setting of the serial
decode bus.
Return Format
<display><NL>
<display> ::= {0 | 1}
Errors
•
See Also
•
"Introduction to :SBUS Commands"
•
•
•
•
•
•
N O T E
This command is only valid on 4 (analog) channel oscilloscope models when a serial decode
option has been licensed.
Summary of Contents for InfiniiVision 7000A Series
