Commands by Subsystem
5
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
487
:TRIGger:CAN:TRIGger
Command Syntax
:TRIGger:CAN:TRIGger <condition>
<condition> ::= {SOF | DATA | ERRor | IDData | IDEither | IDRemote |
ALLerrors | OVERload | ACKerror}
The :TRIGger:CAN:TRIGger command sets the CAN trigger on condition:
•
SOF - will trigger on the Start of Frame (SOF) bit of a Data frame,
Remote Transfer Request (RTR) frame, or an Overload frame.
•
DATA - will trigger on CAN Data frames matching the specified Id,
Data, and the DLC (Data length code).
•
ERRor - will trigger on CAN Error frame.
•
IDData - will trigger on CAN frames matching the specified Id of a
Data frame.
•
IDEither - will trigger on the specified Id, regardless if it is a Remote
frame or a Data frame.
•
IDRemote - will trigger on CAN frames matching the specified Id of a
Remote frame.
•
ALLerrors - will trigger on CAN active error frames and unknown bus
conditions.
•
OVERload - will trigger on CAN overload frames.
•
ACKerror - will trigger on a data or remote frame acknowledge bit that
is recessive.
The table below shows the programming parameter and the corresponding
front- panel softkey selection:
Remote <condition> parameter
Front-panel Trigger on: softkey selection
(softkey text - softkey popup text)
SOF
SOF - Start of Frame
DATA
Id & Data - Data Frame Id and Data
ERRor
Error - Error frame
IDData
Id & ~RTR - Data Frame Id (~RTR)
IDEither
Id - Remote or Data Frame Id
IDRemote
Id & RTR - Remote Frame Id (RTR)
ALLerrors
All Errors - All Errors
OVERload
Overload - Overload Frame
ACKerror
Ack Error - Acknowledge Error
Summary of Contents for InfiniiVision 7000A Series
