516
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
5
Commands by Subsystem
:TRIGger:FLEXray:TRIGger
Command Syntax
:TRIGger:FLEXray:TRIGger <condition>
<condition> ::= {FRAMe | ERRor | EVENt}
The :TRIGger:FLEXray:TRIGger command sets the FLEXray trigger on
condition:
•
FRAMe — triggers on specified frames (without errors).
•
ERRor — triggers on selected active error frames and unknown bus
conditions.
•
EVENt — triggers on specified FlexRay event/symbol.
Query Syntax
:TRIGger:FLEXray:TRIGger?
The :TRIGger:FLEXray:TRIGger? query returns the current FLEXray trigger
on condition.
Return Format
<condition><NL>
<condition> ::= {FRAM | ERR | EVEN}
See Also
•
"Introduction to :TRIGger Commands"
•
•
•
•
":TRIGger:FLEXray:FRAMe:CCBase"
•
":TRIGger:FLEXray:FRAMe:CCRepetition"
•
•
N O T E
This command is only valid when the FLEXray triggering and serial decode option (Option
FLX) has been licensed.
Summary of Contents for InfiniiVision 7000A Series
