730
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
7
Obsolete and Discontinued Commands
:MTESt:LOAD
Command Syntax
:MTESt:LOAD "<filename>"
The :MTESt:LOAD command loads the specified mask file.
The <filename> parameter is an MS- DOS compatible name of the file, a
maximum of 254 characters long (including the path name, if used).
See Also
•
"Introduction to :MTESt Commands"
•
N O T E
The :MTESt:LOAD command is obsolete and is provided for backward compatibility to
previous oscilloscopes. Use the :RECall:MASK[:STARt] command (see
) instead.
Summary of Contents for InfiniiVision 7000A Series
