738
Agilent InfiniiVision 7000A Series Oscilloscopes Programmer's Guide
7
Obsolete and Discontinued Commands
:TRIGger:CAN:ACKNowledge
Command Syntax
:TRIGger:CAN:ACKNowledge <value>
<value> ::= {0 | OFF}
This command was used with the N2758A CAN trigger module for
54620/54640 Series mixed- signal oscilloscopes. The InfiniiVision
7000 Series oscilloscopes do not support the N2758A CAN trigger module.
Query Syntax
:TRIGger:CAN:ACKNowledge?
The :TRIGger:CAN:ACKNowledge? query returns the current CAN
acknowledge setting.
Return Format
<value><NL>
<value> ::= 0
See Also
•
"Introduction to :TRIGger Commands"
•
•
Summary of Contents for InfiniiVision 7000A Series
