266
6000 Series Oscilloscope User’s Guide
6
Displaying Data
To decode I
2
C data
To manually control Serial Decode on 6000L models start the
Remote Front Panel (see
) and select
Waveform
from the
Main Menu or press ctrl+A to access the oscilloscope’s Acquire
Menu.
1
Select the I
2
C serial decode mode:
a
Press the
Acquire
key.
b
Press the
Serial Decode
softkey.
c
In the Serial Decode Menu, press the
Mode
softkey.
d
Use the Entry knob (or repeatedly press and release the
Mode
softkey) to select the
I
2
C
serial decode mode.
N O T E
Because of oscilloscope hardware resource limitations, you cannot
decode I
2
C data while LIN triggering is selected.
N O T E
For I
2
C triggering setup see
Display
decode
Decode
mode
Signal
setup menu
Return to
previous menu
Summary of Contents for InfiniiVision DSO6014L
