Basic Operation
3
N9320B Spectrum Analyzer
31
USB Connection
1
Switch on your N9320B. The standby LED on the front panel
is turned off and the green LED is turned on.
2
Connect your PC to instrument with the USB cable as below.
Figure 4
USB cable for remote control
All of the USB ports are compatible with the USB 2.0 and
1.1 specification. For further information on remote control
and programming, please refer to the
N9320B User’s Guide
in the
N9320B Help Kit
CD.
LAN Connection
After connect the N9320B to the PC with network cable,
please configure the LAN parameters before remote control.
Static IP
The instrument is pre- configured to obtain the static IP
setting. After
connect
the
N9320B
to
LAN
with network
cable, Set the proper IP Address, Gateway and Subnet Mask
to complete the LAN configuration. Those setting will be
work once you press
{Apply}
softkey in IP Admin submenu.
DHCP
Select the
DHCP IP
to obtain an IP Address automatically.
The related LAN parameters will be set once pressing
{Apply}
softkey in IP Admin submenu.
Connecting
PC
Connecting
Device
