Introduction
1
Installation and Verification Manual
15
General Information
Responsibilities of the Customer
The customer shall provide:
1
Access to the products during the specified periods of
coverage to perform maintenance.
2
Adequate working space around the products for servicing by
Agilent personnel.
3
Access to and use of all information and facilities determined
necessary by Agilent to service and/or maintain the
products. (Insofar as these items may contain proprietary or
classified information, the customer shall assume full
responsibility for safeguarding and protection from wrongful
use.
4
Routine operator maintenance and cleaning as specified in
the Agilent Operating and Service Manuals.
5
Consumables such as paper, disks, magnetic tapes, ribbons,
inks, pens, gases, solvents, columns, syringes, lamps, septa,
needles, filters, frits, fuses, seals, detector flow cell windows,
etc.
Certification
Agilent Technologies certifies that this product met its
published specifications at the time of shipment from the
factory. Agilent Technologies further certifies that its
calibration measurements are traceable to the United States
National Bureau of Standards, to the extent allowed by the
Bureau's calibration facility and to the calibration facilities of
other International Standards Organization members.
Assistance
Product maintenance agreements and other customer
assistance agreements are available for Agilent products.
panther3_iv.book Page 15 Wednesday, January 15, 2003 12:03 PM
