Introduction
1
Installation and Verification Manual
21
Connecting to the Network
Connectors for connecting to the network are located on the top
of the instrument. The connections available depend on the
options fitted to your instrument.
For more information, see:
•
•
“Avoiding Optical Receiver Overload"
•
•
“Additional Precautions for Service Engineers"
Laser Warnings and Cautions
Before connecting, note the Warning and Caution information
given.
All Connectors
Optical Interface Connectors
For your protection, review all laser information given in this
manual before installing or using the instrument.
C A U T I O N
When connecting or disconnecting, ensure that you are grounded or,
make contact with the metal surface of the Mainframe with your free
hand to bring you, the module, and the mainframe to the same static
potential.
Modules remain susceptible to ESD damage while the module is
installed in the Mainframe Additional ESD information is required
when servicing, see your Verification manual for further information.
WA R N I N G
To prevent personal injury, avoid use that may be hazardous to
others, and maintain the test set in a safe condition. Ensure the
information given below is reviewed before operating the test set.
panther3_iv.book Page 21 Wednesday, January 15, 2003 12:03 PM
