SureScan Microarray Scanner System
User Guide
28
3
Using the Scan Control Program
To set or change the scan protocol
To change the output folder for a scan
To apply a selection to multiple slides
To add a slide to the scan queue
To add all slides to the queue
To remove a slide from the scan queue
To remove all slides from the scan queue
To change settings for a single slide
To change settings for multiple slides
To add a description for the slide
The Scan Control program is used to control all features of the SureScan scanner, including
setting and changing scan settings and protocols, starting and stopping scans, reviewing scan
status, and troubleshooting.
This chapter describes how you use the Scan Control program to set up and run the SureScan
scanner. For information on how to use the Scan Control Tools to change protocols and scan
regions, and to turn on and off the lasers, see