SureScan System User Guide
71
Output Folder
Displays the folder where image files created by the scanner are saved. By default, this location is
D:\ScanData. You can change the default output folder in T
ools > Settings
. You can change the
output folder for a slide before it is added to the queue. The Browse button lets you select a folder
to store the data from each scan. Agilent recommends that the data be acquired to a local folder
on a secondary hard drive. You can also select a network folder. If a network access problem is
experienced during the scan, data is saved to a temporary local folder, and a warning is included
in the scan log.
Function buttons
Buttons next to the slot table are available depending on the instrument status.
All to Queue
Adds all slides not currently in the slide queue to the slide queue. Slides are added to the queue in
the order they appear in the slot table.
Empty Queue
Removes all slides from the queue, except those currently scanning.
Open Door/
Close Door
Opens or closes the door on the scanner.
Start Scan/
Stop Scan
Starts or stops the scan. Slides are scanned in the order they appear in the scan queue.
