146
Chapter 6
Calibration and Compensation
How to Define Calibration Kit
Figure 6-18
Calibration kit setup window
Step 2.
Specify the table number to define a calibration kit by following the description in “How to
specify table number for setup” on page 104.
Step 3.
Select the type of calibration kit (
7-mm Standard
or
User Defined
) from the
Cal Kit
selection area in the calibration kit setup display.
If you have selected “
7-mm Standard
,” the initial value of the 7-mm calibration kit will be
used as the defined calibration kit. No further setting is required.
NOTE
When you want to used the Agilent 16195B 7-mm calibration kit, select “
7-mm
Standard
.”
If you have selected “
User Defined
,” continue with the following steps:
Step 4.
If you want to use the same definition for all measurement points in the measurement point
table, click the
Fixed Model
button to attach a check mark (
√
).
If you have selected “
Fixed Model
,” set the calibration kit definition for measurement
point number 1. For other measurement points, the same definition as that of measurement
point number 1 is automatically entered.
Step 5.
Select the circuit model to define load from
Rs-Ls, Ls-Q
and
Cp-D
.
Step 6.
Enter open/short/load definitions for each measurement point.
Step 7.
Enter the DC open/short/load definitions.
Step 8.
When you want to use a calibration kit other than the 7-mm calibration kit, you may have
to set the offset delay. If so, enter each value for offset delay open/short/load.
NOTE
The offset delay value is described in the
Operation Manual
of the calibration kit. Please
refer to this manual.
Summary of Contents for Twelfth 4287A RF LCR
