Chapter 11
245
Setting and Using the Control and Management Facilities
System Recovery
1
1
. Setting
and Using the
Contr
o
l an
d Man
age
men
t
Fac
ilities
Step 6.
The following screen appears. Select “+Removable Devices” with
of the
keyboard, and press
of the keyboard.
Step 7.
The message as shown below appears. Press
of the keyboard. If you want to cancel the
create user backup image, press
here.
Agilent Technologies System Utilities
Recovery & Backup Options
Choose One of the following:
_________________________________________________________________
1. Recover Factory Backup Image
2. Create User Backup Image
3. Recover User Backup Image
4. Exit
_________________________________________________________________
Enter a Choice: _
NOTE
If the above message does not appear, the instrument or the disk for the system recovery is
at fault; contact your local Agilent customer center listed at the end of this manual or
distributor.
Summary of Contents for Twelfth 4287A RF LCR
