110
Chapter 5
Setting Measurement Conditions
How to Set the Measurement Point
How to change oscillator level
Change the oscillator level of an already set measurement point by following these steps:
Step 1.
Use the mouse to select the oscillator level cell at the measurement point you want to
change.
Step 2.
Enter a new oscillator level by pressing the numeric entry keys of the entry block (
[0]
to
[9]
,
[-]
and
[.]
and
[
×
1]
sequentially.
To set the oscillator level to -10 dBm, for example, press
[-]
,
[1]
and
[0]
(Figure 5-8) and
then
[
×
1]
.
Figure 5-8
How to change oscillator level
Summary of Contents for Twelfth 4287A RF LCR
