148
Chapter 6
Calibration and Compensation
How to Define Compensation Kit
Figure 6-20
Compensation kit setup window
Step 2.
Specify the table number to define a compensation kit by following the description in
“How to specify table number for setup” on page 104.
Step 3.
Select the type of compensation kit (
Default
or
User Defined
) from the
Compen Kit
selection area in the compensation kit setup window.
If you have selected “
Default
,” the initial value of the predetermined compensation kit will
be used as the defined compensation kit. No further setting is required.
If you have selected “
User Defined
,” continue with the following steps:
Step 4.
If you want to use the same definition for all measurement points in the measurement point
table, click the
Fixed Model
button to attach a check mark (
√
).
If you have selected “
Fixed Model
,” set the compensation kit definition for measurement
point number 1. For other measurement points, the same definition as that of measurement
point number 1 is automatically entered.
Step 5.
Enter open/short definitions for each measurement point.
Step 6.
Enter the DC open/short definitions.
Summary of Contents for Twelfth 4287A RF LCR
