194
Chapter 8
Sorting According to Measurement Results
Example of Settings for BIN Sorting
Figure 8-18
Setting the measurement point number (Stimulus) for Condition 1
Step 3.
Set the measurement parameter for Condition 1 to Ls.
Figure 8-19
Setting the measurement parameter for Condition 1
Step 4.
Next, use the following procedure to set the setting mode for the range of sorting for
Condition 1.
a.
Click the limit setting mode (Mode) cell in the Condition 1 column to select the cell.
b.
Click the down-arrow
that appears in the right side of the cell.
c.
In the drop-down list box that appears, click “PCNT” (percent) (Figure 8-20).
Summary of Contents for Twelfth 4287A RF LCR
