230
Chapter 11
Setting and Using the Control and Management Facilities
Configuring the Network
Step 5.
The Local Area Connection Properties dialog box (Figure 11-3) appears. Select (highlight)
Internet Protocol (TCP/IP)
(1 in Figure 11-3) and then click the
Properties
button (2 in
Figure 11-3
Local Area Connection Properties dialog box
Step 6.
The Internet Protocol (TCP/IP) Properties dialog box (Figure 11-4) appears. Click (select)
Use the following IP address
(1 in Figure 11-4) and then enter the IP address (2 in Figure
11-4), the subnet mask (3 in Figure 11-4), and the gateway address (4 in Figure 11-4).
If the IP address can be obtained automatically (if the DHCP server can be used), click
(select)
Obtain an IP address automatically
(5 in Figure 11-4).
Figure 11-4
Internet Protocol (TCP/IP) Properties dialog box
Summary of Contents for Twelfth 4287A RF LCR
