76
Chapter 4
Function Overview
Names and Functions of Parts on the Front Panel
6. Instrument state block (INSTR STATE)
This block contains a group of hardkeys used to set up the functions to control and manage
the comparator, measurement result display, trigger, saving, calling up, and others.
7. Entry block (ENTRY)
This block contains a group of hardkeys for entering numerical values and strings of
characters. You can operate these keys after moving the cursor to the position where you
want to enter numerical values and strings of characters with the keys or the mouse.
[Prmtr] key
Displays the Prmtrs softkey menu in the softkey area on the
right side of the display. These softkeys are used to select
the measurement parameter.
[Cal/Compen] key
Displays the Cal/Compen softkey menu in the softkey area
on the right side of the display. This menu is used to
execute calibration and compensation.
[Display] key
Displays the Display softkey menu in the softkey area on
the right side of the display. This menu is used to specify
how to display the measurement results.
[Capture] key
This key uses the same hardkey as the
[Display]
key. When
the key is pressed, an image of the screen at that point in
time is copied to the clipboard (temporary memory). This
temporarily saved image data can later be named with a
filename and saved on a storage device (floppy disk or
nonvolatile memory).
[Trigger Mode] key
Displays the Trigger Mode softkey menu in the softkey
area on the right side of the display. This menu is used to
set the measurement start instruction method (trigger
mode).
[Save/Recall] key
Displays the Save/Recall softkey menu in the softkey area
on the right side of the display. This menu is used to save
the 4287A setup state and measurement data in a storage
device of the 4287A (floppy disk or nonvolatile memory)
and to call them up when needed.
[Trigger] key
This is a manual trigger key. The trigger is activated by
pressing this key in the manual trigger mode.
[System] key
Displays the System softkey menu in the softkey area on
the right side of the display. This menu is used to control
and manage the entire measuring instrument.
[0] through [9][.][-] keys
(numeric entry keys)
These keys are used to enter numerical values at the cursor
position. You can confirm the setup based on the entered
numerical value by subsequently pressing a unit key.
Summary of Contents for Twelfth 4287A RF LCR
