10
ROUTe Subsystem
92
U2300A Series USB DAQ Programming Guide
ROUTe:CHANnel:STYPe
Syntax
ROUTe:CHANnel:STYPe <mode>, (@<ch_list>)
This command is used to set the reference ground selection of the
specified analog input channel
.
ROUTe:CHANnel:STYPe? (@<ch_list>)
The query command returns a string value representing the signal type of
both specified analog inputs and outputs. Multiple responses are separated
by commas.
Supported Model
U2351A, U2352A, U2353A, U2354A, U2355A, U2356A, U2331A
Parameters
Item
Type
Range of Values
Default Value
<mode>
String
DIFF: Differential mode
SING: Referenced single-ended mode (16/64 ch common to
ground system on board)
NRS: Non-referenced single-ended mode (16/64 ch common to
AISENSE pin)
SING
<ch_list>
Numeric
Single-ended mode:
U2351A/U2352A/U2353A/U2354A: 101-116
U2355A/U2356A/U2331A: 101-164
Differential mode:
U2351A/U2352A/U2353A/U2354A: 101-108
U2355A/U2356A/U2331A: 101-132
N/A
Summary of Contents for U2300A Series
