5
CONFigure Subsystem
30
U2300A Series USB DAQ Programming Guide
CONFigure:SSI
Syntax
CONFigure:SSI <mode>
This command sets the synchronization status (master/slave) when used in
the U2781A modular instrument chassis.
CONFigure:SSI?
The query command returns a string value, which represents the
synchronization status (master/slave).
Supported Model
U2351A, U2352A, U2353A, U2354A, U2355A, U2356A, U2331A
Parameters
Remarks
•
This command will force all reference clock sources to synchronous
serial interface (SSI).
•
Once a module is configured as a slave (via
CONFigure:SSI:SLAV
), it
becomes a listener and listens for triggering signals on the backplane of
the U2781A chassis. To undo this listener behavior, a
CONFigure:SSI:NONE
command must be applied to the slave module.
Item
Type
Range of Values
Default Value
<mode>
String
NONE: None
MAST: To function as SSI master triggering
source
SLAV: To receive triggering source from
master
NONE
N O T E
•
This command is only operational when used in U2781A modular
instrument chassis.
•
There should only be one master assigned.
Summary of Contents for U2300A Series
