11
SENSe Subsystem
100
U2300A Series USB DAQ
[SENSe:]VOLTage:RANGe
Syntax
[SENSe:]VOLTage:RANGe <range>, (@<ch_list>)
This command is used to set or inquire the analog input (AI) range of the
specified channel. It selects the voltage measurement rangeof the
designated channels.
[SENSe:]VOLTage:RANGe? (@<ch_list>)
The query returns a discrete value representing the voltage value for
current input voltage on each specified analog input channel. Multiple
responses are separated by commas.
Supported Model
U2351A, U2352A, U2353A, U2354A, U2355A, U2356A, U2331A
Parameters
Query Returned Format
<range> [V]
Item
Type
Range of Values
Default Value
<range>
Discrete
U2331A:
Unipolar mode: {AUTO|10|5|4|2.5|2.0|1.0|0.5|0.4|0.1}
Bipolar mode: {AUTO|10|5|2.5|2.0|1.25|1.0|0.5|0.25|
0.2|0.05}
U2351A/U2352A/U2353A/U2354A/U2355A/ U2356A:
Unipolar|Bipolar mode: {AUTO|10|5|2.5|1.25}
AUTO
<ch_list>
Numeric
Single-ended mode:
U2351A/U2352A/U2353A/U2354A: 101-116
U2355A/U2356A/U2331A: 101-164
Differential mode:
U2351A/U2352A/U2353A/U2354A: 101-108
U2355A/U2356A/U2331A: 101-132
N/A
Summary of Contents for U2300A Series
