4.
Q&A
Q
:
HUNTER SE is started up correctly, but why cannot the RC transmitter control the vehicle body to move?
A:
First, check whether the vehicle’s power supply is in normal condition, and whether E-stop switches are released; then, check
whether the control mode selected with the top left mode selection switch on the RC transmitter is correct.
Q: HUNTER SE remote control is in normal condition, and the information about chassis status and movement can be
received correctly, but when the control frame protocol is issued, why cannot the vehicle body control mode be switched
and the chassis respond to the control frame protocol?
A:
Normally, if HUNTER SE can be controlled by a RC transmitter, it means the chassis movement is under proper control; if
the chassis feedback frame can be received, it means CAN extension link is in normal condition. Please check the CAN control
frame sent to see whether the data check is correct and whether the control mode is in command control mode. You can check
the status of error flag from the error bit in the chassis status feedback frame.
Q: HUNTER SE gives a "beep-beep-beep..." sound in operation; how to deal with this problem?
A:
If HUNTER SE gives this "beep-beep-beep" sound continuously, it means the battery is in the alarm voltage state. Please
charge the battery in time.
