21
Cobra
USER MANUAL
H. Adjust the necessary adjustment using the MAIN MENU (See Part 2.2.2).
NOTE:
After configuration is complete, select EXIT on the MAIN MENU and push the OK button to leave
the MAIN MENU. All settings will be saved.
9. To operate the Cobra with wireless remote control, turn the operation switch to the STB position
(Standby). After it the remote control button can activate/ deactivate the device in two ways:
1) To turn the device on, press the remote control button once, to turn it off – press the button
again.
2) To operate the device in short-time activation mode (see note below), press and hold the
remote control button down for 1.5+ seconds. Release the remote control button to deactivate
the device.
CAUTION:
DO NOT leave the equipment activated when not in use.
2.3.2 COBRA SHUT-DOWN
NOTE:
Shut down the Cobra properly to avoid losing unsaved settings and data.
Shut-down the Cobra as follows:
1. Be sure to save your settings and data.
2. Turn off the Cobra.
3. Place the protective cap on the objective lens.
4. Disconnect the cable (if applicable).
5. Place the protective cap on the connector.
6. Remove the batteries.
CAUTION:
Do not store the Cobra with the batteries still installed.
7. Store the Cobra and all accessories in the carrying case.
Summary of Contents for COBRA TB50-336
Page 1: ...USER MANUAL COBRA THERMAL IMAGING BI OCULAR...
Page 31: ......
