Place the floor
92-01
on your worktop. Check how the
turbine support
92-02
fits on the floor: four raised
sockets on the underside of part
92-02
fit over raised
pegs on the floor
92-01
, as indicated.
05
06
Insert the remaining seven transverse dividers from
frame
92-05
. They slot into the guides in the same
way as the first divider.
Take the five matching transverse support brackets
A
from frame
92-06
. These fit on the top of the turbine
support
92-02
, parallel to the brackets that are part
of the support panel. Pegs on the lower edges of the
brackets fit into holes in part
92-02
. Note the position
of the notched edge of the brackets (thick red arrow).
03
04
Glue the four bolts
92-04
into the sockets in the
turbine support
92-02
, as shown.
Take the eight transverse dividers from frame
92-05
.
Slide the first divider into the slots on the floor
92-01
and underside of the turbine support
92-02
. Note the
orientation of the floor/support assembly and the
notch on the corner of the divider (thick red arrow).
02
. ASSEMBLING THE TURBINE ROOM
Apply some glue to the four pegs on the floor
92-01
and fix the turbine support
92-02
in place. Remove
the four bolts from the frame
92-04
.
92-01
92-01
92-05
92-02
92-04
A
92-02
92-01
92-02
92-02
92-02
92-04
92-04
92-05
01
02
50
49
AGORA
MODELS
50
AGORA
MODELS