11
F E R R A R I 3 1 2 t4
P a c k 1 1 . S TA G e 9 5
95-06
Disconnect the two
clear tubes from the oil filter
couplings, pass them under
the roll-bar tie-rods and under
the cables of the distributor
wires. Cut a 13 mm long
section from the tube,
then a second, longer
33–35 mm section.
Now reconnect the
tubes to the same
connections you
disconnected
them from.
95-07
Cut
one end of
the short
tube cut in
the previous
step so that it
is bevelled to
about 45°.
Fit the short
tube over the
tank breather
filter, as in the
image.
95-09
Pass the free end of
the tube to the left (in the
direction of travel) of the
headrest.
95-08
Connect the
longer tube
cutting to the
fitting on the
canister of
compressed
air inside the
roll-bar.
08
06
09
07