6
F E R R A R I 3 1 2 t4
P a c k 1 1 . s ta g e 9 4
94-01
Place the model on your
work surface. Note the seatbelts,
which are slightly raised against
the surface of the seat.
94-03
Remove the protective
film and, with tweezers, lift
one of the two seatbelts and
place the two-sided tape on
the bottom side, just under
the buckle.
94-04
Press gently onto the belt to make sure
that it adheres to the seat, and then repeat this
step for the other seatbelt.
94-05
Now take the silver tape. Cut a strip and secure
it to the work surface with adhesive tape. Use a
ruler and a sharp cutter and make vertical cuts
to obtain strips 3 mm wide and approx. 12 mm
long as shown.
94-02
Take a strip of two-sided tape and apply
it to the work surface. Cut two strips 4–5 mm
wide and approx. 12–13 mm long.
05
03
02
01
04