5
GB
SAFETY INSTRUCTIONS
WARNING! Read all safety warnings and all instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injuries.
Save all warnings and
instructions for future reference.
•
This power tool is intended to function as a sander. Read all safety warnings, instructions,
illustrations and specifications provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock, fire and/or serious injury.
•
Operations such as grinding, wire brushing, or for polishing and cut-off are not recommended to
be performed with this power tool.
Operations for which the power tool was not designed may create a
hazard and cause personal injury.
•
Do not use accessories which are not specifically designed and recommended by the tool
manufacturer.
Just because the accessory can be attached to your power tool, it does not assure safe
operation.
•
The rated speed of the accessory must be at least equal to the maximum speed marked on the
power tool
. Accessories running faster than their rated speed can break and fly apart.
•
The outside diameter and the thickness of your accessory must be within the capacity rating of
your power tool.
Incorrectly sized accessories cannot be adequately guarded or controlled.
•
Threaded mounting of accessories must match the grinder spindle thread. For accessories mounted
by flanges, the arbour hole of the accessory must fit the locating diameter of the flange.
Accessories
that do not match the mounting hardware of the power tool will run out of balance, vibrate excessively
and may cause loss of control.
•
Do not use a damaged accessory. Before each use inspect the accessory such as abrasive wheels for
chips and cracks, backing pad for cracks, tear or excess wear, wire brush for loose or cracked wires.
If power tool or accessory is dropped, inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and bystanders away from the plane of
the rotating accessory and run the power tool at maximum no-load speed for one minute.
Damaged
accessories will normally break apart during this test time.
Symbols used in this manual
V…….........volts
A…….........amperes
Hz…….......hertz
W……........watt
~………....alternating current
n
0
………...rated speed
min
-1
….......revolutions or reciprocation
per minute
.........warning of general danger
.…..class II tool
.......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
.....wear safety-approved hard hat
do not dispose of electric tools,
accessories and packaging together
with household waste material
