AGRETO Hydraulic Scale
© AGRETO electronics GmbH
page:14
9.7
Error messages
Error
Description
Action
(U - - - - )
Underload
Increase load or switch the
scale off and back on again
(O - - -- -)
Overload
Reduce load
(TARE)
(ERROR)
Taring attempt outside of the
permitted range
Reduce tare
(ZERO)
(ERROR)
Zeroing attempt outside of the
permitted range
Reduce load
(STABLE)
(ERROR)
A [ZERO] or [TARE] command
can't be executed because the
scale is unstable
Try again when the scale is
stable
(SPAN)
(LO)
The difference between zero
point and calibration weight is
too small
Use a higher calibration
weight
E0200
Calibration is lost
Make a new calibration
E0400
All settings are lost
Make all settings and the
calibration again
E2000
Scale is not connected
Turn off the indicator
Connect the scale
Turn on the indicator
E2000
Weighing signal out of range
Check cable and plugs for
damage
Summary of Contents for B300-V4-K354
