AGRETO LoadCounter II M
© AGRETO electronics GmbH
page:10
no further movement within the set time, the counting is stopped and the sum is
reset to the initial value.
1 = summation starts immediately after the first movement
20 = default
100 = summation is started after 100 seconds
In counting mode, this parameter determines the length of a rest period in
seconds, during which the count continues without interruption. If another
movement follows within the set time (which is strong enough), the complete
time is added up, including the rest phase. If the rest period lasts longer than
the set time, the count stops and the sum is reset to the value at the beginning
of the rest phase. The meter is now in idle mode.
1 = summation is stopped immediately at the end of the movement
20 = default
100 = A rest period of up to 100 seconds is counted
Parameter UnIt - Display format (operating mode 5B)
This parameter determines the format of the hour display.
00:59 = default setting, display in hours and minutes (hhhh:mm)
00,99 = display in hours with 2 decimal places (hhhh,hh)
By default, the display is in hours and minutes, and the colon is used as the
separator.
If necessary, you can change the display to decimal hours, here the comma is
used as separator.
6.6
Zeroing the counter
To reset the counter, press and hold all 3 buttons together for 3 seconds. When
released, all totals are set to 0.
