4
TO REMOVE UNIT FROM CARTON
•
Cut from top to bottom all four corners of the carton
and lay panels flat. See figure 1.
•
Remove the lag screw that holds the floating hitch to
the packing skid.
•
Disassemble and discard carton's wood top and side
supports.
•
Remove four hex bolt, hex nuts and flat washer from
the hold down brackets at the rear of the carton.
•
Remove and save the two Flat Washers and Cotter Pins
from rear axle. Reuse when attaching gauge wheels.
•
Discard all other packing hardware and hold down
brackets.
ASSEMBLY
TO iNSTALL ThE TiLLER GAUGE WhEELS
•
Assemble Gauge Wheels onto the Rear Axle with
the extended end of Hub facing inward. Secure with
the Flat Washers and Cotter Pins which you removed
from the axle during unpacking. See figure 2.
3/8" NYLOCK
NUT
TO iNSTALL ThE TiLLER TiNE ASSEMBLiES
•
Attach the floating hitch to the tractor's draw bar.
Refer to
OPERATING INSTRUCTIONS
on page 6.
•
Remove the preassembled 3/8" x 2" hex bolt and 3/8"
nylock nut from the L.H. Tine Assembly. Slide the tine
assembly onto the Transmission Axle on the left side
of the tiller and secure with the hex bolt and nylock
nut. See figure 3. Repeat for the R.H. side.
TO INSTALL (WHEEL) WEIGHTS TO TILLER
NOTE:
Weights are not furnished with Tiller. 30 lb. tractor
wheel weights may be purchased to mount to Tiller if
extra weight is required. (Refer to
OPERATION
section.)
•
Remove two Hex Bolts and Nuts from each Tine
Shield, located approximately 3-1/2" from front edge.
See figure 4.
•
Place (Wheel) Weights on Tine Shield and secure
with long Bolts and Nuts furnished with Weights. See
figure 4.
FiGURE 1
FiGURE 2
FiGURE 3
FiGURE 4
