USO
6
USE
6-4
FL - FP - FA
6.3
Avviamento per inizio lavoro
• Collegare i tubi dei martinetti, due per lo sposta-
mento laterale e due per l’inclinazione, agli attacchi
presenti sulla trattrice.
• Sollevare la trinciatrice da terra ed escludere i piedi
d'appoggio
posizionando la spina d’arresto nel
foro più basso
.
• Abbassare la trinciatrice finché il rullo sia a contatto
con il terreno.
• Innestare la presa di forza e lasciare lentamente la
frizione onde evitare sforzi eccessivi sugli organi di
trasmissione.
• Mandare a regime la presa di forza della trattrice
(540 o 1000 giri/minuto) rispettando il numero di giri
indicato nella decalcomania applicata sulla trincia-
trice.
• Determinare la velocità di avanzamento in funzione
del tipo di prodotto da trinciare e del grado di frantu-
mazione che si vuole ottenere. Velocità d’avanza-
mento consigliata 3 km/h.
• In caso di manovra si consiglia di sollevare legger-
mente la trinciatrice da terra.
• Se il terreno su cui si lavora presenta piccoli dossi,
in corrispondenza di questi dislivelli si consiglia di
alzare sufficientemente la trinciatrice. Superata la
zona critica, riabbassare la trinciatrice e riprendere
il lavoro normale.
6.3
Starting and operating the shredder
• Connect the jack hoses to the joints fitted on the
tractor, two for the lateral displacement and two for
the inclination.
• Elevate the shredder from the ground, and retract
the support feet by positioning the break-pin in the
lowest hole.
• Lower the shredder, until the roller touch the ground.
• Insert the PTO and slowly release the clutch, in
order to avoid overloading the transmission organs.
• Make the tractor PTO reach the correct speed (540
or 1000 rpm). Make sure the correct rpm indicated
by the decal on the shredder is respected.
• Set the advance speed according to the type of
material to be shredded and the desired crushing
degree. Reccomended advance speed 3 km/h.
• In case of manoeuvres, it is recommended that the
shredder is slightly raised from the ground.
• If the working ground presents little humps, it is
advisable to lift the shredder to overcome the drop.
Once the critical point is over, lower again the shred-
der and resume normal operation.
Summary of Contents for FA 150
