19
If you have ground moist grains, moisture condensation may have
accumulated in the grinding chamber. Leave the mill open for approx.
1 hour after the grinding (upper and lower parts separated). This
allows moisture to escape from the grinding chamber.
Important: Then close the mill again (assemble the upper part and
the lower part) in order to avoid wood warping
.
Important!
Never leave the mill open in parts (hopper and motor part
separate), but leave the whole mill ready for service. You will thus avoid any
possible deformation of the wooden parts due to humidity.
Against moths and insects:
Place a tea bag (herbal) in the flour spout. Put bay leaves in the upper and
lower parts of the mill.
Moths love dark conditions, where they can survive in peace and quiet! They
eat only flour and no wood. Provided your mill is frequently used, you will not
be offering moths a comfortable place to stay.
Care and cleaning of the housing:
The housings of our mills are made from solid beech wood, which has been
treated with special organic oil-beeswax oil. No special maintenance is
required.
Please use a damp cloth to remove dust from exterior surfaces. Do not use
water or other detergents for “cleaning”. Stains or small scratches can be
removed with fine-grained sand paper. Finally treat the wood with a natural
protective.
