8
Moths love the dark and their peace and will only start attacking any
wood if they are faced with extreme emergency. If you constantly use
your mill you will not other moths any comfortable surroundings.
Prior to delivery the shaft bearing has been oiled, but application of a
little sewing machine oil will ensure long-life of your mill. The outer
surfaces of your mill need only to be wiped with a damp cloth and
then dried at once.
Occasionally roughen the outside surfaces with sand paper and then
treat them with beeswax oil.
Milling Process
Fill appropriate material into the funnel.
Using the clamps supplied with the mill fix it firmly onto a stable table – table
surface over the corner.
Slowly begin to rotate in a clockwise direction.
The degree of fineness of the flour can be adjusted during the milling
process.
Please see the chapter on „Adjusting the degree of fineness.”
Interrupting the milling process
When beginning to mill hard grain types such as corn, rice or durum wheat
At fine settings and with a full funnel the mill can become blocked. Please re-
adjust the setting from? ne to coarser until the mill begins to turn then during
the milling process adjust the setting in a clockwise direction until the desired
degree of? neness is reached.
When milling wheat, spelt or rye should the mill stones become blocked,
please give the funnel a short turn backwards in the ANTI-CLOCKWISE
direction.
A tip: the less? our is between the millstones the easier the funnel
can be turned.
