9
Adjusting the degree of fineness
Coarse / fine adjustment is possible by using the knurled nut
and is locked by applying the wing nut.
Coarse Setting:
Loosen the wing nut, adjust the knurled nut in the anti-clockwise direction
until you have the desired setting. Then tighten the wing nut.
Fine Setting:
Loosen the wing nut, adjust the knurled nut (in the clockwise direction) until
desired grade is reached. Then tighten the wing nut.
The MH 8 grain mill can be continually adjusted and according to the adjust-
ment chosen, produces the results required.
Opening the milling chamber
The unity of the funnel and upper millstone is fixed by the fine adjustment
mechanism on the base part of the mill. The fine adjustment is located on
the upper part of the mill. By unscrewing the fine adjustment the funnel can
be lifted off.
Place the funnel unit onto the guide rod which is fixed in the lower part of
the part of the appliance. Please refer to the drawing to see the order of the
components.
Please clean the stones before attaching the funnel unit.
If your grain was not dry enough for the chosen mill setting, the grain will
smear the millstones. A hard, but smooth layer will appear on the millstones.
Take a kitchen knife and scratch the layer from the millstones. Clean the
grooves in the millstones. In order to clean the millstones, it is usually only
necessary to process 1 or 2 hand-falls of rice or grain at a coarse setting. Any
adhesions can be easily and quickly removed.
