15
Operating time up to 35 minutes
Your mill has been designed for processing household quantities. Should you
occasionally require an unusual amount of flour that is no problem!
However, the mill may turn itself off during the milling process. There is no
need to worry, the mill has not been damaged! Leave it to cool off for about
1 hour.
Adjusting the degree of fineness
The Salzburger grain mill can be steplessly adjusted by turning the hopper and
can be re-set during the milling process without any problems. For fixing the
milling setting there is a locking screw on the right hand side of the mill.
Operation of the locking screw:
Turn the locking screw gently and with feeling into the thread. Use of
force must be avoided! After a few turns you will notice that the
thread blocks and that the hopper can no longer be moved.
Firm tightening of the locking screw is NOT required.
The thread must not be allowed to move independently during
the milling process. Should the thread move (correct the position
of the thread) and slightly tighten the locking screw.
CAUTION!
!
If you turn the locking screw too tightly into the thread, the
locking screw, the milling chamber and the seal can be damaged. At the
same time pressure on the thread and the altered position of the mill
stones makes it impossible for the mill to process finely and the flour
becomes too hot.
Any damage to the thread due to incorrect use of the locking screw
could lead to extensive and costly repair work, which is not covered
by the terms of warranty.
