User manual
Safety instructions
32
ChC_Safety_B-GB
06/12/2019
NOTE
Refer to the tractor's registration documents to obtain the authorised values for the total weight,
axle loads and tyre load capacities.
The calculated actual values must be less than or equal to (≤) the authorised values.
WARNING
Risk of crushing, cutting, entanglement, entrapment and impact through insufficient stability of
the tractor under load and insufficient tractor manoeuvrability and braking power.
It is forbidden to couple the machine to the tractor used as the basis for calculation if:
-
even if one of the actual, calculated values is greater than the authorised value.
-
there is no front weight (if required) attached to the tractor corresponding to the minimum required front
ballast (G
V min
).
Ballast the tractor with a front or rear weight when the tractor's axle load is exceeded on only one axle.
Special cases
If the minimum required ballast at the front (G
V min
) is not obtained with the weight of the front-mounted machine
(G
V
), you must use ballast weights in addition to the front-mounted machine.
If the minimum required ballast at the rear (G
H min
) is not obtained with the weight of the rear-mounted machine
(G
H
), you must use ballast weights in addition to the rear-mounted machine.
Immobilising the tractor / machine
WARNING
Accidents involving crushing, shearing, cutting, tearing, entanglement, winding, entrapment or
impact may occur when working on the machine in the following cases:
-
accidental lowering of a non-immobilised machine, raising of the tractor's three-point hitch
via the hydraulic circuit.
-
accidental lowering of raised, non-immobilised components of the machine.
-
accidental start-up and movement of the combined tractor-machine.
Before carrying out any operations on the machine, take all necessary measures to prevent any accidental
start-up or movement of the combined tractor-machine.
Operations performed on the machine, e.g. fitting, adjustment, troubleshooting, servicing and repair, are prohibited:
-
if the machine is running,
-
while the tractor's engine is running with a connected transmission shaft / hydraulic system,
-
when the ignition key has not been removed and the tractor's engine with a connected transmission shaft
/ hydraulic system can be accidentally started,
-
when the tractor and machine are not immobilised with their respective parking brakes and/or chocks,
-
when moving parts are not blocked against accidental movement.
These operations in particular carry a risk of contact with non-immobilised components.
Lower the machine / parts of the machine that are raised and not immobilised.
The way to avoid any accidental lowering is as follows:
1 -
Switch off the tractor engine,
2 - Remove the ignition key,
3 - Apply the tractor's parking brake.
4 - Immobilise the machine (only for a hitched machine):
•
on a flat surface using the parking brake (where applicable) or chocks,
• on sloped or uneven ground using the parking brake and chocks.
Summary of Contents for 5 Series
