35
(V) Running-in of Diesel Engine
Diesel before use must be running, running - can make the surface by moving parts of the diesel
engine to achieve a good fit for each, in order to avoid abnormal wear and damage. Diesel engine
service life, reliability and economy work, to a large extent depends on the initial run-good or bad.
Run-diesel can be carried out together with the supporting machinery, running time is 40 to 60
hours. During the run, the load should not exceed 70% of the specified load, the speed shall not exceed
80% of rated speed. Do not let the engine idle for a long time, after the end of the run, after running to
be "forced to go together maintenance" (see Chapter III, seventh). Recommended to the Agrison Power
technical service stations of were " compulsory running-in maintenance."
(1). Diesel is not allowed in the case of cooling fluid "boil" work, and do not work in the long-term
water temperature is too high or too low.
(2).Diesel engine is not allowed to run at idle for more than 10min.
The user of harvester engine should run it strictly according to the following specification.
1.Run at idle for 5 minutes.
2.Diesel engine from the accelerator semi open transition to open the throttle fully in place 1 hours of
operation,careful observation of the diesel engine is working properly.
3.Diesel engine with the harvest units on-site 3 hours of operation from the accelerator semi opentrans
to open the throttle fully.
