INSTRUCTIONS FOR USE
AGP 300 – 600 PRO
Rev.02/2019
51
Turn on the pump and let it run for approximately one minute under minimum pressure in order
to aerate the pump and the inlet and the outlet pipes. (increase the pressure [+] using the switch on
the control panel.
Be careful not to exceed the maximum allowed pressure and the maximum allowed rpm of 540.
On the opposite, the manufacturer cannot be held responsible for any kind of damage that could
occur.
11.3
After use
Some chemical agents can shorten the durability of some vital parts of the pump such as rubber
membranes and other rubber seals. Therefore a thorough washing of the pump after each single
spraying is recommended. To do this, you will need to pump some clean water through the pump.
Let the pump operate at working pressure for several minutes. Lower the pressure and let the pump
operate for approximately one minute to blow out the rest of the liquid.
During winter, leave all of the water out of the pump and/or protect the pump against freezing (see
chapter
Napaka! Vira sklicevanja ni bilo mogoče najti.
).
11.4
Technical data
WARNING: Never turn on the pump’s drive when the setting on the
regulator enables full load on the pump.
PUMP MARKING
APS 121
NOMINAL FLOW RATE
l/min
120
Max. OPERATING PRESSURE
bar
50
Max. NO. OF REVOLUTIONS
rpm
540
REQUIRED POWER
kW
10,7
NO. OF PRESSURE DIAPHRAGMS
pc
3
WEIGHT
kg
38
OIL
SAE
SAE 30
