7
© Agrowtek Inc. | www.agrowtek.com
The main menu is how the alarms are set, sensors are calibrated and general
settings such as time, date and units are configured.
If a dosing pump is directly connected to the SXHM GrowNET port, the pump
settings are also accessed by the main menu.
Use the
UP
or
DWN
buttons to navigate the menu.
Use the
ENT
button to enter a selection.
Main Menu
GPH MNU
H/L
72.0
6.10
1550
600
°F
pH
uS
mV
High and low alarm set points may be configured for each sensor value to
activate an internal buzzer or send alerts with the optional wifi module.
The out-of-range value will be displayed in
red
to indicate the cause for the
alarm.
Additionally, alarm limits are plotted on the graphs to indicate values are
within the desired range.
Alarms Menu
DWN ENT
UP
EXIT
ALARMS
CALIBRATION
SETUP
PUMPS
MENU
GPH MNU
H/L
72.0
6.10
1550
600
°F
pH
uS
mV
DWN ENT
UP
EXIT
ALARMS
CALIBRATION
SETUP
PUMPS
MENU
DWN ENT
UP
EXIT
ALARMS
CALIBRATION
SETUP
MENU
DWN ENT
UP
BACK
+0.1
-0.1
SET LOW
0.0°F
1. Select
ALARMS
from the main menu.
3. Select the setting
to adjust.
2. Select a sensor to
configure set points.
4. Adjust to the desired
value. Hold
UP
or
DWN
to jog the value.
DWN ENT
UP
BACK
LOW: 0.0
HIGH: 0.0
ALARM: OFF
ALARM
DWN ENT
UP
BACK
TEMPERATURE
PH
COND
ALARMS
ORP
Alarms Configuration
GPH MNU
H/L
72.0
5.14
1550
600
°F
pH
uS
mV