sales@agrotkindustrial.com
https://www.agrotkindustrial.com/
P18
OPERATION INSTRUCTIONS
diameter
（
d
）
value
：
automatically read it from the rim
，
input through
Pic.9
2)
put down the hood and press key, then the main shaft start to rotate
3) There are two ways to check the unbalanced result
3.1 set the option SLC to OFF. (stick the block manually)
3.2 Rotate slowly the tire anticlockwise by hand until the outer side of indicator lights are all on
，
at the point of
12 O’clock is the unbalance point of alignment plane. Balance alignment planes are as shown in below
pictures. Paste corresponding balance weight on the outside of the wheel rim. See pic.10
Pic.10
