Ae-man-817-0.0 v2.3 10 AGUILERA ELECTRONICA
AE/SA-IDC AE/SA-GAT COMMUNICATION INTERFACE
2.2
EQUIPMENT DETECTION.
In this step the programme tries to communicate with the AE/SA-IDC or AE/SA-GAT communication
Interface through the communication port selected in the previous step. Steps to be followed are shown
on the screen.
If communication is successful, the present equipment customization can be red to allow to be modified in
later steps.
Otherwise, the process can be repeated by pressing the button “Detect” or back to the previous step and
selecting another communication port if we have made a mistake.
NOTE:
Unless the interface has not been customized, it is necessary to switch the equipment off and
then switch it on again. Press the button “Detect” before 5 seconds for the customizer to detect the
interface correctly. During these first 5 seconds, the interface remains in a special mode of configuration,
“listening” in its two ports the arrival of a customizer command. If no command arrives after some
seconds, the equipment will be reset automatically and starts to operate according to its customization.
Summary of Contents for AE/SA-GAT
Page 2: ......
Page 6: ...Ae man 817 0 0 v2 3 4 AGUILERA ELECTRONICA AE SA IDC AE SA GAT COMMUNICATION INTERFACE...
Page 40: ...Ae man 817 0 0 v2 3 38 AGUILERA ELECTRONICA AE SA IDC AE SA GAT COMMUNICATION INTERFACE...
Page 62: ...Ae man 817 0 0 v2 3 60 AGUILERA ELECTRONICA AE SA IDC AE SA GAT COMMUNICATION INTERFACE...
