Ae-man-817-0.0 v2.3 42 AGUILERA ELECTRONICA
AE/SA-IDC AE/SA-GAT COMMUNICATION INTERFACE
6.1.2.1
NETWORK
CONFIGURATION.
Firstly, information corresponding to “
Basic Settings
” should be expanded by clicking on the folder on the
left panel.
We will access the configuration page of the network parameters of the equipment by selecting the
“Network Settings”
option on the left panel.
On this page the IP Address the equipment will have should be entered, as well as the network mask.
The rest of parameters are not usually necessary but it is appropriate to confirm it with the network
administrator where the Communication Interface is going to be installed.
After entering the needed data, press the
“Submit ”
button and the following window will be shown:
Press the “
Back
” button to continue the modification of parameters.
6.1.2.2
CONFIGURATION OF THE SERIAL
P
ORT
.
Next, we should check that the configuration of the serial Port of the micro server is correct.
In order to do that, we will select the
“Serial Port Settings”
option on the left panel and we will ensure
that all data is configured as shown in the window below:
Summary of Contents for AE/SA-GAT
Page 2: ......
Page 6: ...Ae man 817 0 0 v2 3 4 AGUILERA ELECTRONICA AE SA IDC AE SA GAT COMMUNICATION INTERFACE...
Page 40: ...Ae man 817 0 0 v2 3 38 AGUILERA ELECTRONICA AE SA IDC AE SA GAT COMMUNICATION INTERFACE...
Page 62: ...Ae man 817 0 0 v2 3 60 AGUILERA ELECTRONICA AE SA IDC AE SA GAT COMMUNICATION INTERFACE...
